OM-1308 Page 6
2-3. Volt-Ampere Curves
ssb1.1 10/91 – SB-144 925 / S-0700
1 Normal Volt-Ampere Curves
The volt-ampere curves show the
normal minimum and maximum
voltage and amperage output capa-
bilities of the welding power source.
Curves of other settings fall be-
tween the curves shown.
2 Overload Volt-Ampere Curves
When unit is used beyond capacity,
circuitry senses the overload and
shuts down unit output. Release
trigger and lower weld voltage set-
ting before trying to weld. This shut
down circuitry protects internal
circuits and parts from overload
damage.
0
10
20
30
40
50
60
0 50 100 150 200 250 300 350 400
DC VOLTS
DC AMPERES
1
*
*
*Approximate shutdown voltage/amperage
points shown for reference only.
2
2-4. Installing Work Clamp
1 Work Cable
2 Boot
Slide boot onto work cable. Route
cable out front panel opening from
inside.
3 Negative (–) Output Terminal
Connect cable to terminal and
cover connection with boot.
4 Hardware
5 Work Clamp
Route cable through clamp handle
and secure as shown.
Close door.
ST-150 228-E
Tools Needed:
1/2, 3/4 in
3
2
1
5
4
Commentaires sur ces manuels